What to do if Olivetti d-COPIA 3013MF ejects blank sheets?
If your Olivetti All in One Printer is ejecting blank sheets, check if the originals are loaded correctly. When placing originals on the platen, place them face-down and align them with the slit glass. When using the document processor, ensure originals are placed face-up.
Why are my Olivetti d-COPIA 3013MF printouts too light?
If the printouts from your Olivetti All in One Printer are too light, verify these possible causes: Ensure that the machine is not in Manual Density mode, and if it is, select the correct density level. Shake the toner container from side to side to distribute the toner evenly. If there is a message indicating the addition of toner, replace the toner container. Replace the paper if it is damp. Disable EcoPrint mode if it is enabled. Also, ensure the paper type setting is correct for the paper being used.
Why my Olivetti d-COPIA 3013MF cannot print?
If your Olivetti All in One Printer is not printing, check the following: Ensure the power cord is plugged into an AC outlet, the printer is powered on, and the printer cable is securely connected. If the machine was powered on before connecting the printer cable, power it on again after connecting the cable. Also, check if the print job is paused; if so, press [Resume]. Finally, if an error message is displayed, follow the corresponding procedure.
General| Brand | Olivetti |
|---|---|
| Model | d-COPIA 3013MF |
| Category | All in One Printer |
| Language | English |
To Next Page