Why Olivetti All in One Printer cannot perform memory reception?
Your Olivetti All in One Printer might be unable to perform memory reception if there is not enough free space available in the memory. Receive after creating free space in the memory.
What to do if my Olivetti d-Copia 3003MF All in One Printer shows a machine failure error?
If your Olivetti All in One Printer displays a machine failure error, try turning the power switch off and on, or unplug the power cord and plug it back in. If the message persists, take note of the error code, then turn off the power switch, unplug the power cord and call your service representative.
Why Olivetti d-Copia 3003MF All in One Printer cannot send document?
Your Olivetti All in One Printer might fail to send a document due to several reasons: * The modular cord may not be connected correctly. Ensure it is properly connected. * A communication error might be displayed. Address the cause of the error and attempt to send again. * The TX (transmission) restriction could be activated. Cancel the TX restriction and try again.
Why Olivetti All in One Printer cannot receive document?
Your Olivetti All in One Printer may be unable to receive a document due to the following: * The modular cord may not be correctly connected. Ensure the modular cord is properly connected. * A communication error might be displayed. Remedy the cause of the error and ask the sender to retry sending the document. * The RX (reception) restriction might be activated. Cancel the RX restriction.
What to do if Olivetti d-Copia 3003MF All in One Printer says job accounting restriction exceeded?
If your Olivetti All in One Printer displays a 'Job Accounting restriction exceeded' message, it means that the number of papers used has exceeded the limit preset by Job Accounting. Press the OK key to cancel the job. Try again after resetting the limit for paper use.
Why Olivetti d-Copia 3003MF All in One Printer cannot use the remote switching function?
Your Olivetti All in One Printer may be unable to use the remote switching function if: * A pulse line is being used. Some phones may transmit tone signals using buttons. Refer to the operation manual of your phone set. * The remote switching number is incorrect. Check the registration; the default is 55.
Why Olivetti All in One Printer cannot use polling reception?
If your Olivetti All in One Printer cannot use polling reception, verify with the recipient that polling transmission is being used correctly on the sending machine.
Why Olivetti All in One Printer cannot use sub address bulletin board communication?
Your Olivetti All in One Printer might fail to use sub address bulletin board communication because: * The other party's fax machine might not have the same sub address bulletin board communication function. Check with the recipient. * The entered sub address or sub address password might be incorrect. If your entry is correct, check with the recipient.
Why is there no print output after reception on my Olivetti d-Copia 3003MF All in One Printer?
If there is no print output after reception on your Olivetti All in One Printer, check the forwarding destination because memory forwarding might be activated.
Why Olivetti d-Copia 3003MF cannot perform broadcast transmission?
Your Olivetti All in One Printer may fail to perform broadcast transmission if there is not enough free space available in the memory. Send the transmission after creating free space in the memory.
General| Functions | Print, Copy, Scan, Fax |
|---|---|
| Duplex Printing | Yes |
| Copy Resolution | 600 x 600 dpi |
| Fax Transmission Speed | 33.6 Kbps |
| Paper Size (Max) | A4 |
| Printing Technology | Laser |
| Print Speed (Black) | 30 ppm |
| Print Resolution | 1200 x 1200 dpi |
| Copy Speed (Black) | 30 cpm |
| Connectivity | USB, Ethernet |
| Operating System Compatibility | Windows, Mac |
To Next Page