16
P/N 30149, Rev. G [12/15/2016]
A.5 Final Check Out
Verify all safety devices and electrical components have
been set for normal operation.
Verify all electrical connections are tight and wiring is
secure.
Verify homeowner is informed and understands:
Where circuit breaker or fuse is located in main electrical
panel.
Where furnace switch is located, and switch "on" and "off"
positions if not obvious.
APPENDIX A - CHECK OUT AND ADJUSTMENTS
FIGURE 3: UNITED TECHNOLOGIES 1158-120 FAN
TIMER BOARD (BML)
FIGURE 4: UNITED TECHNOLOGIES 1168-1 ECM
TAP BOARD (BMLV)
Where oil shut-off valve from oil storage tank is located.
Thermostat operation, and other related accessories.
How to operate manual reset button on primary control,
and when not to push the reset button.
How and where to visually inspect venting system for leaks
or other problems.
How to inspect, clean and replace air lter, and other
homeowner maintenance procedures.
Who to call for emergency service and routine annual
service.
To Next Page
Loading...
