23
Power on/off
1
Getting started
When playing back pictures (Playback mode)
Power on: Slide the power switch to .
The camera turns on in the playback mode. The monitor
turns on and the last picture taken is displayed.
If no pictures have been taken yet, or the xD-Picture card is
empty, the message “NO PICTURE” is displayed on the
monitor.
Power off: Slide the power switch to OFF.
The monitor and the camera turn off.
• Even if the monitor is turned off, the battery power is
consumed unless the power switch is located at OFF.
TIPS
• When the camera turns on, the monitor may light up momentarily and a
picture may be displayed briefly. This is not a malfunction.
• Never open the card cover, remove the card or the batteries, or connect
or disconnect the AC adapter while the camera is turned on. Doing so
could destroy all data on the card. Destroyed data cannot be restored.
When changing the card, be sure to turn the camera off before opening
the card cover.
Power switch
Power switch
Note
To Next Page
Loading...
