24
1
Power on/off
Getting started
If the card is not recognized (card check)
When the power is turned on, the camera checks the card automatically.
If there is no card in the camera or a card that is not supported by this camera
is inserted, one of the following screens will be displayed.
• All data stored on the card is erased when the card is formatted.
Monitor
indication
Corrective action
NO CARD
There is no card in the camera or the card is not
inserted properly.
→ Insert a card. If a card is already inserted, remove it
and insert it again correctly.
The card cannot record, play back or erase pictures.
Replace with a new card, or format the card.
→ Press to select POWER OFF, and press
. Replace it with a new one.
→ Format the card.
Press to select FORMAT, and press
to display the confirmation screen. Select YES and
press .
Formatting starts. If the card was successfully
formatted, the camera is ready to take pictures.
Note
To Next Page
Loading...
