Olympus CAMEDIA C-700 Ultra Zoom - Single Frame Erasure-Erase Button

69
3
Single frame erase — Erase button
 Check the following before erasing pictures.
● Make sure the card is not write-protected. If so, remove the write-protect seal.
● NEVER open the card cover, eject the card, remove the batteries, or pull out the plug
when the card access lamp is blinking during picture erasure. Doing so may destroy
data stored on the card.
 Canceling single frame erasure
Press
ñ to select NO, then press or the button.
ERASE
YES
N O
SELECT GO
1
Select a picture you wish to erase
using the Arrow pad (P.38, 42).
● Cancel the Protect setting (P.79) if it
is on.
2
Press the (Erase) button.
● The ERASE screen asking you to
confirm the erasure will appear.
3
Press Ñ to select YES.
4
Press to erase the picture.
DRIVE/ (Erase) button (Cont.)