80
E
◆ When the camera is being operated on battery
power and the batteries are running low, the
camera may emit several short beeps and blink
the number of storable pictures on the control
panel after you take a shot or when you open the
lens barrier. If this happens, the picture you have
just taken will not turn out properly. Replace the
batteries and take the picture again.
Note:
1 Close the lens barrier halfway.
2 Wait until the lens is recessed.
● Do not push the lens barrier against the lens.
3 Close the lens barrier all the way.
● The power goes off.
4 Close the flash.
Turning off the power
To Next Page
Loading...
