Olympus DS-2400 - Setting Device Time and Date; Manual Time and Date Setup Process

17
1
PLAY/OK
Setting Time and Date (Time & Date)
Setting Time and Date
Setting the correct time and date on the recorder
is very important since every file recorded on the
recorder will have the time and date information
as part of the file header. This will simplify the
file management aspects later on.
The hour indicator will flash automatically
when you load batteries before using the
recorder for the first time, or after the
recorder has not been used for a long time.
BACK EXIT
Time & Date
10 M 14 D 2008 Y
5: 00 PM
24H
BACK EXIT
Time & Date
10 M 14 D 2008 Y
5 : 45 PM
24H
F1, F2, F3 button
PLAY/OK,+, –,
9, 0
button
1
Press the 9 or 0 button to select
the item to set.
Select the item from “hour”, “minute”, “year”,
“month” and “day” with a flashing point.
2
Press the
+
or
–
button to set.
Follow the same steps by pressing the 9 or
0 button to select the next item, and press
the
+ or – button to set.
•You can choose between 12 and 24 hour
display by pressing the F2(24H or 12H)* button
while setting the hour and minute.
Example: 5:45 P.M.
5:45 PM (Initial setting)←→ 17:45