143
EN
Using separately sold accessories
9
Other external fl ash units
Use after connecting the synchro cord to the hot shoe
or external fl ash jack. When not using an external fl ash
terminal, be sure to attach the cap.
When attaching a third-party fl ash to the camera’s hot shoe
or external fl ash jack, be careful of the following points.
Cap
• Using obsolete fl ash units that apply currents of more than about 250 V to the X-contact
will damage the camera.
• Connecting fl ash units with signal contacts that do not conform to Olympus specifi cations
may damage the camera.
• Set the Shooting mode to M, set the shutter speed to a value no higher than fl ash
synchronous speed, and set ISO sensitivity to a setting other than [AUTO].
• Flash control can only be performed by manually setting the fl ash to the ISO sensitivity
and aperture values selected with the camera. Flash brightness can be adjusted by
adjusting either ISO sensitivity or aperture.
• Use a fl ash with an angle of illumination suited to the lens. Angle of illumination is usually
expressed using 35-mm format equivalent focal lengths.
Principal Accessories
Four Thirds lens adapter (MMF–2/MMF–3)
The camera requires a Four Thirds lens adapter to attach Four Thirds lenses. Some
features, such as autofocus, may not be available.
Remote cable (RM–UC1)
Use when the slightest camera movement can result in blurred pictures, for example
for macro or bulb photography. The remote cable attaches via the camera multi-
connector. (P. 10)
Converter lenses
Converter lenses attach to the camera lens for quick and easy fi sh-eye or macro
photography. See the OLYMPUS website for information on the lenses that can be
used.
• Use the appropriate lens attachment for SCN mode (f, w, or m).
Eyecup (EP-16)
You can exchange this for a larger eyecup.
Removing
To Next Page
Loading...
Need help?
General
Weight and Dimensions
