47
EN
Setting the shutter speed on the camera
Set the shutter speed in accordance with the fi ring frequency and the number
of fi rings set on the fl ash as described below.
Shutter speed (sec.) ≥ Number of fi ring (TIME) ÷ Firing frequency (Hz)
Example:
When “10” is set for the number of fi ring (TIME) and “5” is set for the fi ring
frequency (Hz), set the shutter speed longer than the value (sec.) calculated
in the following formula.
10 ÷ 5 = 2
Shooting Tips
Adjusting the distribution of light Adjusting the distribution of light
You can switch between the standard mode and the wide mode. The wide mode
is useful when you want to illuminate the surroundings more uniformly. When the
fi ring angle is 12 mm or less, the light distribution does not change.
1
Hold down the ZOOM button until “W” (wide)
appears on the control panel.
• To cancel the setting, hold down the ZOOM button
until “W” (wide) disappears from the control panel.
MODE LEDZOOM
W
mm250.0
Off
M
RANGE
0.7~8.0
m
TTL
Tilting the fl ash window (bounce fl ash photography) Tilting the fl ash window (bounce fl ash photography)
By changing the angle of light from the fl ash to
the subject, you can control the appearance of
shadows. You can also refl ect the light off the ceiling
or walls to soften shadows on the subject.
90°
180°
180°
Flash
window
PUSH
button
1
Hold down the PUSH button and tilt the fl ash window upward,
downward, to the left, or to the right.
To Next Page
Loading...
