53
EN
Setting the fl ash compensation (# +/-) in the TTL or FP TTL mode
Press the a button to highlight +/- RATIO. Then,
turn the dial to adjust the setting.
• You can set a fl ash compensation from -5 to +5.
Press the OK button.
MODE
A
B
C
ZOOM CH
A
mm75
0.0
1
FP
RATIO
0.0
1/8
TTL
TTL
M
Off
Setting the fl ash intensity (RATIO) in the M, FP M, or MULTI mode
Press the a button to highlight +/- RATIO. Then,
turn the dial to adjust the setting.
• You can set a fl ash ratio from 1/1 to 1/128.*
1
MODE
A
B
C
ZOOM LED
0.0
RATIO
0.0
1/8
TTL
TTL
M
1/4
1/8
1/16
Scale display*
2
*1 You can select 1/2 EV or 1/3 EV for the adjustment
increment. (P. 60)
*2 On the scale display, t is the current selection. u is the
previous setting.
Press the OK button.
Setting the fi ring angle (ZOOM) in the # CMD mode
Press the ZOOM button to highlight ZOOM. Then, turn the dial to adjust the
setting.
• When you select A (auto), an automatic setting takes effect. The automatic
setting ranges from 12 mm to 75 mm.
• When the fl ash window is adjusted for bounce fl ash photography, you cannot
select A (auto).
• When you select M (manual), you can set a fi ring angle from 12 mm to 75 mm.
Press the OK button.
Setting the FP mode
Press HI on the arrow pad to highlight FP. Then, turn the dial to adjust
the setting.
• You can select On (enable) or Off (disable).
MODE
A
B
C
FP CH
0.0
1
RATIO
0.0
1/8
TTL
TTL
M
On
CMD mode
MODE
A
B
C
ZOOM CH
A
mm12
0.0
1
FP
RATIO
0.0
1/8
TTL
TTL
M
On
#CMD mode
• Refer to “Firing the Flash at a High Shutter Speed (FP TTL Mode / FP M
Mode)” (P. 44) for details.
Press the OK button.
To Next Page
Loading...
