Olympus Mju 1050 SW - Underwater Use and Maintenance; Preparation and Usage Precautions; Storage and Maintenance

67 EN
Before Use:
Checkthecameraforforeignmaterial
includingdirt,dustorsand.
Besuretoclosethebattery/cardcompartment
coverandconnectorcoverrmlysothateach
lockmakesclickingsound.
Donotopenthebattery/cardcompartment
coverandconnectorcoverwithwethands,
whileunderwater,orinadampordusty
environment(e.g.beach).
Usethecameraunderwaterwiththelens
barrierinthedownposition.Toturnthe
cameraonandoffunderwater,usetheo
button.
After Use:
Donotslidethelensbarrierupuntilthe
camerahasbeenrinsedwithwater.
Besuretowipeoffanyexcesswaterordebris
afterusingthecameraunderwater.
After the camera is used under seawater,
immerse the camera in a bucket containing
fresh water for about 10 minutes (with
the battery/card compartment cover and
connector cover rmly closed). After
that, dry the camera in a shade with good
ventilation.
Water drops may be observed on the inner
surface of the battery/card compartment
cover or connector cover after you open
each cover. If any water drops are found,
be sure to wipe them off before using the
camera.
Notes after use
Foreignmaterialsmaybeattachedtothe
peripheryofthelensbarrierfromusingthe
camerainconditionswithforeignmaterials
suchasdirt,dustorsand,orwhenthelens
barrierisnotmovingsmoothly.Ifyoucontinue
tousethecamerainsuchconditions,thelens
couldbecomedamagedorthelensbarrier
couldstickcausingadditionaldamagetothe
camera.Toavoidsuchdamage,washthe
camerausingthefollowingmethod.
1 Insertthebatteryandclosethebattery/
cardcompartmentcoverandconnector
coverrmlysothateachlockmakesthe
clickingsound.
2 Fillabucketwithfreshwater,immerse
thecamerainthebucketwiththelens
surfacedownwardandshakethecamera
thoroughly.
•
•
•
•
•
•
•
•
•
3 Rinsethefrontofthecamerawithrunning
waterwhilethelensbarrierisopen.
FollowSteps
1to3,thencheckifthelens
barriermovessmoothly.Ifthelensbarrierdoes
notmovesmoothly,rinsethelensbarrierby
placingitdirectlyunderfastrunningwater.
Storage and Maintenance
Donotleavethecamerainanenvironmentat
hightemperature(40°C(104°F)ormore)orat
lowtemperature(-10°C(14°F)orless).Failure
todosomaybreakdownwaterresistance.
Donotusechemicalsforcleaning,rust
prevention,anti-fogging,repairing,etc.Failure
todosomaybreakdownwaterresistance.
Do not leave the camera in water for a long
time. Failure to do so will cause damage to
the camera’s appearance and/or deteriorate
water resistance.
In order to preserve the water resistant
feature, as with any underwater housing,
it is recommended that the waterproof
packing (and seals) are replaced annually.
For the Olympus distributors or service
stations where the waterproof packing can
be replaced, visit Olympus website for your
local area.
•
•
•
•