Olympus OEP-3 - Section 2 Service Information; Main Parts Location; Board Location

1-15
OEP-3 V1 (UC)
28
Operation
Making Full-Size Image Printouts (Continued)
P
1
[
1-9
]
RINT QTY :
PRINT QTY. : 1 [ 1 ~ 9 ]
Making Multiple Copies of Identical Printouts
You can make up to 9 copies of identical printouts.
Setting the printout quantity
The following two methods are available to set the number of printouts.
• Using the PRINT QTY button. However, you cannot use the button to decrease
the number of printouts.
• Using the menu
You can change the designated number of copies before printing or any time
during printing.
To set the printout quantity by using the PRINT QTY button
1
Press the PRINT QTY button.
The following screen appears.
If you do not perform any operation after you press the PRINT QTY button,
the currently set number of copies appears for about 3 seconds, after which it
disappears.
1,2
Currently selected number of copies
29
Operation
P
/c/ l /PRN/i /o/
RINTER SETUP
PRINTER SETUP COLOR : 200
/ COL / LAY / PRN / IN / OUT /
PRINT QTY. : 1 [ 1 ~ 9 ]
INTERVAL : OFF / ON
GAMMA : S / NORMAL / H
PRN SPEED : / HIGH
MOTION CHK : OFF / ON
LOAD USER : 1 / 2 / 3 [ EXEC ]
SYSTEM : PRESS [ > ]
FUNCTION : PRESS [ > ]
C - BALANCE : PRESS [ > ]
Q1 A 1
S
2
Press the PRINT QTY button until the desired number appears.
Repeatedly pressing the PRINT QTY button increases the number up to a
maximum of 9. Or repeatedly pressing the g button also increases the number
up to a maximum of 9.
To decrease the number of copies
While the screen which appears in step 1 is being displayed, press the G button.
Each time you press the G button, the number decreases and stops at 1.
Setting the printout quantity using the menu
1
Press the MENU button.
The menu previously opened appears.
2
Select PRN by pressing the G or g button.
The PRINTER SETUP menu appears.
1,5
2,4
3
Switch PRN to green by pressing
the G or g button.
Display PRN in capital letters by
pressing the G or g button.
P
3
[
1-9
]
RINT QTY :
PRINT QTY. : 3 [ 1 ~ 9 ]
Press the PRINT QTY button or g button until the desired number appears.
Continue to the next page c