106
Chapter 5 Operation
VIDEO SYSTEM OTV-SI
• The remote control switch assignments are retained when
the video system is turned OFF and turned ON again.
• Each menu item’s corresponding functions and operational
references are shown in Table 5.2.
Menu item Function Operation from the remote control
switches
Reference
NONE Inactive – –
ENH. [ ] Image enhancement Each time the switch is depressed, the
mode cycles through 0 (OFF), 1(LOW),
2(MEDIUM), 3(HIGH).
Section 5.7, “Image
enhancement”
BRI.
Exposure up Pressing the switch increases brightness. Section 5.6, “Brightness
adjustment”
BRI.
Exposure down Pressing the switch decreases brightness. Section 5.6, “Brightness
adjustment”
FREEZ Freeze Pressing the switch turns the freeze function
ON and OFF.
Section 5.10, “Freeze”
RELES Release Pressing the switch releases the image to
the OEP-3 or OEP.
Section 5.15, “Photography
with the color video printer
(OEP-3/OEP-not available
in some countries)”
VTR Recording image with a
VTR
Pressing the switch changes between
record and pause.
Section 5.16, “Recording
with the video tape
recorder”
ZOM [ ] Zoom Pressing the switch changes between
normal and magnified image.
Section 5.11, “Zoom”
W/B Automatic white
balance
Each time the switch is pressed for more
than 1 second, the white balance is
adjusted.
Section 5.5, “Color
adjustment”
ROT [ ] Rotated image Pressing the switch changes between the
normal and rotated images.
Section 5.17, “Rotated
image”
MES [ ] Iris Pressing the switch changes between
center and full.
Section 5.6, “Brightness
adjustment”
EXEC Execution Pressing the switch executes the menu
operation.
Section 5.2, “Basic menu
operation”
MOVE Selection Pressing the switch selects the menu. Section 5.2, “Basic menu
operation”
LC [ ] Brightness control Pressing the switch changes between
automatic and manual brightness control.
Section 5.6, “Brightness
adjustment”
PMP [ ] Air feed pump Pressing the switch turns the air feed ON
and OFF.
Section 5.18, “Air/water
feed (type B only)”
Table 5.2
To Next Page
