Olympus OTV-SI - Page 87

Chapter 5 Operation
81
VIDEO SYSTEM OTV-SI
Figure 5.34
 Using the menu
1. If the video monitor does not display the menu, press the remote control
switch for execution or for selection, the “F1”, “Enter”, “  ”, “  ”, “” or “”
key on the keyboard to display the menu.
2. Press the remote control switch for selection, the “” or “” key on the
keyboard and select “NEXT” (see Figure 5.6 on page 57).
3. Press the remote control switch for execution, the “Enter” or “  ” key on the
keyboard to display the menu bar shown in Figure 5.35.
Figure 5.35
Auto indicator
Auto/Manual
brightness selector
Manual indicator
VISY218