Using Electronic Flashes Other Than Olympus T-Series Units
(1) Mount the flash on the accessory shoe.
The OM-PC does not accept flash units with-
out direct hot shoe contacts.
(2) Setting the aperture
If you are using an automatic flash, check the
specifications on the flash and set the aperture
accordingly.
If you are using a manual flash, determine the
required aperture by the following formula.
You can also use the flash's calculator panel
and set the aperture based on this information.
Aperture =
Flash guide number
Flash-to-subject distance
(3) Switch the camera's mode selector dial to
MANUAL and shoot with a shutter speed of
1/60 sec. or slower.
* Read the instruction manual of your flash
carefully.
60
To Next Page
Loading...
