CMOS color camera SC100
20
4.4 Step 4: Selecting the camera
After you have selected the camera driver, you have to choose the camera for the
MS-Windows XP operating system. This fourth installation step is similar to step 3,
but instead of the USB 2.0 Camera driver the camera SC100 is shown. The MS-
Windows XP operating system automatically starts the Found New Hardware wizard
again.
1) Select the option No, not this time in the dialog box. Then, click the Next >
button.
2) In the dialog box that follows, select the Install from a list or specific location
(Advanced) option. Then, click the Next > button.
3) In the following dialog box, select the Don’t search. I will choose the driver to
install. option. Then, click the Next > button.
To Next Page
Loading...