Olympus SP-590 UZ - Using a microSD Attachment; Olympus Wireless RC Flash System

74 EN
Using a microSD Attachment
 DonotusetheattachmentwithOlympus
digitalcamerasthatdonotsupportthis
microSDAttachment,aswellaswithother
brandsofdigitalcameras,computers,
printersandotherdevicesthatsupport
xD-PictureCard.Doingsonotonlymay
damagethepicturestaken,butmayalso
resultinthemalfunctionofthedevice.
 IfthemicroSDcardcannotberemoved,
donotuseforce.Contactauthorized
distributors/servicecenters.
Cards compatible with this camera
microSDcard
microSDHCcard
 ForalistoftestedmicroSDcards,please
visitourwebsite(http://www.olympus.com/).
Sending images
Youcansendimagestoacomputeror
PictBridgecompatibleprinterbyusingthe
USBcableprovidedwiththecamera.
Tosenddatatootherdevices,remove
theattachmentfromthecameraanduse
acommerciallyavailablemicroSDcard
adapter.
Handling precautions
Donottouchthecontactareaofthe
attachmentormicroSDcard.Doingso
maycausefailureinreadingtheimages.
Whenngerprintsorstainsarefoundon
thecontactarea,wipetheareawithasoft
drycloth.
Taking pictures with the
Olympus Wireless RC Flash
System
Youcantakepictureswithawirelessash
whenusingaashcompatiblewiththeOlympus
WirelessRCFlashSystem.Thisenables
multi-ashphotographyusingmultipleash
unitscompatiblewiththissystem.Thecamera’s
built-inashisusedforcommunicationbetween
thecameraandash.
 Fordetailsaboutoperationofawireless
ash,refertotheinstructionmanualforthe
specialexternalash.
1 Set the wireless ash based on the
guidelines below.
Wireless ash setup range guidelines
 Thesetuprangevariesdependingonthe
ambientenvironment.
5
m
50°
50°
1
0
m
30°
30°
50°
50°
30°
30°
Pointtheremote
sensortoward
thecamera
Flashdirection
2 Turn on the wireless ash.
3 Use the MODE button on the
wireless ash to set to RC mode,
and make the channel and group
settings.
ThegroupissettoA.(TheBandCsettingsdo
notwork.)
4 Turn on the camera, and press the
# button to ip up the built-in ash.
5 Set [QFLASH] (p. 36) on the
camera to [#RC], and set the
channel (CH1 to CH4) to the same
setting as the wireless ash.
●