Olympus SZX2-ILLT - Attaching the Antiglare Plate

SZX2-ILLT
10
Fig. 10
Fig. 11
3
Attaching the Antiglare Plate
(Figs. 10 & 11)
}The antiglare plate attaching methods are variable between model SZX2-
CCV (for use with the SZX2 series) and SZX-CCV (for use with the SZX
series).
SZX2-CCV
1. Loosen the antiglare plate clamping knob @ and insert the pin ³ on the
antiglare plate into the positioning hole on the left side of the zoom
microscope body ².
2. Rotate the antiglare plate in the direction of the arrow so that it comes in
close contact with the zoom microscope body.
3. Insert the clamping knob @ into the positioning hole | on the right side,
and tighten the knob to fix the antiglare plate.
SZX-CCV
1. Loosen the two antiglare plate clamping knobs @ and fit the antiglare
plate into the tip of the objective ².
2. Tighten the two clamping knobs @ to fix the antiglare plate.
@
³
²
²
@
|