Olympus U-LH50HG - Proper Selection of the Power Supply Cord

30
REFLECTED FLUORESCENCE SYSTEM FOR CKX41
PROPER SELECTION OF THE POWER SUPPLY CORD
If no power supply cord is provided, please select the proper power supply cord for the equipment by referring
to “ Specifications ” and “ Certified Cord ” below:
CAUTION:
In case you use a non-approved power supply cord for Olympus products, Olympus can
no longer warrant the electrical safety of the equipment.
Specifications
Voltage Rating
Current Rating
Tem pe r a tu re Ra t in g
Length
Fittings Configuration
125V AC (for 100-120V AC area) or, 250V AC (for 220-240V AC area)
6A minimum
60°C minimum
3.05 m maximum
Grounding type attachment plug cap. Opposite terminates in molded-on
IEC configuration appliance coupling.
Table 1 Cer t i f i ed Cord
A power supply cord should be certified by one of the agencies listed in Table 1 , or comprised of cordage
marked with an agency marking per Table 1 or marked per Table 2. The fittings are to be marked with at least
one of agencies listed in Table 1. In case you are unable to buy locally in your country the power supply cord
which is approved by one of the agencies mentioned in Table 1, please use replacements approved by any
other equivalent and authorized agencies in your country.
Country Agency
Certification
Mark
Country Agency
Certification
Mark
Argentina
Australia
Austria
Belgium
Canada
Denmark
Finland
France
Germany
Ireland
IRAM
SAA
ÖVE
CEBEC
CSA
DEMKO
FEI
UTE
VDE
NSAI
Italy
Japan
Netherlands
Norway
Spain
Sweden
Switzerland
United
Kingdom
U.S.A.
IMQ
KEMA
NEMKO
AEE
SEMKO
SEV
ASTA
BSI
UL
JET, JQA , TÜV,
UL-APEX / MITI