Key designators followed by (1.5s), e.g.
(1.5s)
, indicate that the key should be
pressed and held for 1.5 seconds, then released to access the desired function.
Measurement settings are configured in the Setup Menu. Press
(1.5s)
to access the Setup
Menu. From within the Setup Menu, press to step through the user-definable parameters
and the keys to increment/decrement or
keys to move left/right while in the
Setup Menu. The active parameter value will flash on the display or the active digit indicator
will flash beneath the digit.
Press to save a setting and exit the Setup Menu. Press to disregard unsaved changes
and exit the Setup Menu. If no key is pressed for 10 seconds, the current configuration is
saved and the instrument will exit the Setup Menu.
Figure 5 lists the user-definable parameters and the available values for each parameter.
To set a parameter value:
1. Press
(1.5s)
to enter the Setup Menu;
2. Press to cycle through parameters as shown in Figure 6 until the desired
parameter is reached;
3. To change the value of the current parameter, press
or ;
4. To save the current parameter value and cycle to the next parameter, press
(1.5s)
;
5. To save the current parameter value and exit the Setup Menu, press ;
6. To disregard changes made to the current parameter value and exit the Setup
Menu, press .
7. If parameter 2, “Temperature and Voltage Units” are set as either “°C” or “°F”, the
remaining parameter choices available are in Figure 5 below under “Setup Choices
for °C and °F”. If parameter 2 is set to “mV”, the remaining parameter choices
available are in Figure 5 below under “Setup Choices for mV”.
To Next Page
Loading...
