Omlet Eglu Cube Instruction Manual

Page4
Using the clipping method described
above, clip the rear panel to the
frames in the positions shown by
the symbols in the diagram.
Bolt the Rear Panel to the base
using two P-Clips in the positions
shown
Now tighten up all 8 bolts that hold
the frames to the base, making
sure the frames are pushed as
near to the edge of the base as
they will go.
Clip the Small Side Panels to the
Frames. Ensure that you use the
correct Small panel on each side.
The edge that has a bit of skirt
sticking out should be towards the
back of the eglu.
Bolt each Small Side Panel to the
Base with a P-Clip.
To join a run panel to the base you
need to use a P-clip. Simply slide the
Clip over a wire of the Run panel and
using a Small Bolt, bolt the clip to the
Base.
Step 4 - Clip the Rear Panel to the Wheel Assemblies
Step 5 - Clip the Small Side Panels to the Wheel Assemblies
squeeze
To join two run panels together, you
need to use the Clips supplied. Simply
spread the arms and place a
round the
two wires to be joined. Squeeze the
clip and it will close up and join the
wires as shown in the diagram.
If you wish to undo a clip, spread the
‘arms’ apart
. You may fi nd it easier
to use a coin or knife to spread the
arms.
How do I use a
P-clip?
How do I use the
Run Clips?

Omlet Eglu Cube Specifications

General

Ventilation	Adjustable ventilation system
Capacity	Up to 10 chickens
Features	Easy to clean, secure fox-resistant run, integrated nesting box
Color	Green or Purple
Portability	Fitted with wheels for easy movement
Included Accessories	Nesting box, roosting bars