Stereo Separation: > 65 dB, 30 Hz – 15 kHz.
Linear Crosstalk: > -80 dB, main to sub or sub to main channel
(referenced to 100% modulation).
Non-linear Crosstalk: > -80 dB, main to sub or sub to main channel
(referenced to 100% modulation).
38 kHz Suppression: > 70 dB (referenced to 100% modulation).
76 kHz Suppression: > 80 dB (referenced to 100% modulation).
Pilot Protection: > -65 dB relative to 9% pilot injection, ± 1 kHz.
57 kHz (RDS/RBDS) Protection: better than -50 dB.
Connectors: Two EMI suppressed female BNC, floating over chassis
ground.
Maximum Load Capacitance: 5nF (at 10 ohms source impedance).
Maximum cable length: 100 feet/30 meters RG-58A/U.
HD Radio Specifications (DAB)
Frequency Response: Within ± 0.50 dB, 30 Hz to 20 kHz.
Distortion: No greater than 0.01% THD 20 Hz – 20 kHz bandwidth.
Signal-to-Noise Ratio: > -100 dB, 20 Hz –- 20 kHz bandwidth, referenced to 0dBfs
Stereo Separation: Greater than 95 dB, 20 Hz –- 20 kHz; 85 dB typical.
Analog Audio Input: Configuration: Left/Right Discrete Stereo. Electronically balanced, floating and
symmetrical.
Input impedance: 10k ohms resistive, electronically balanced.
Maximum Input Level: +24 dBu.
Nominal Input Level: A 13dBu input signal nets a –12dBFS input meter
reading when the Input Gain Control is set to 0.0 dB. A 1dBu input signal
nets a -12dBFS input meter reading when the Input Gain Control is set to
+12 dB.
(Note: When the Input Gain and Master Drive controls are set to 0.0 dB,
a +13dBu input signal results in an input level of –12dBFS, and a
Wideband AGC gain reduction of –15dB.
A/D Conversion: Crystal Semiconductor CS5360, 24 bit 128x over-sampled delta sigma
converter with linear-phase anti-aliasing filter. Pre-ADC anti-alias filter,
with high-pass filter at <10 Hz.
Connectors: Two EMI-suppressed XLR female. Pin 1 chassis ground, and Pin 2 is “hot”.
Analog Audio Output: Configuration: Left/Right Discrete Stereo. Electronically balanced,
Source Impedance: 20 ohms, electronically balanced and floating.
Load Impedance: 600 ohms or greater, balanced or unbalanced.
Output Level (100% peak modulation): Adjustable from -6 dBu to +24
dBu peak, into 600 ohms or greater load, software-adjustable.
D/A Conversion: Crystal Semiconductor CS4390 24 bit, 128x over-sampled.
Connectors: Two, EMI-suppressed XLR-male. Pin 1 chassis ground, Pin 2 “Hot”.
Omnia-6ex Use and Operation Manual – V: 1.10
8
To Next Page
Loading...
