Omnia 6EX - System Parameters (Sysparas); Setting New Syspara Values

Omnia-6EX System Parameters
A 'syspara' is an Omnia 6 System parameter. The System Parameters are assigned to controls which govern overall
operation, such as Input and Output Gains, Pre-emphasis/De-emphasis, etc. These parameters would NOT be saved
with individual presets, but instead are saved using the Save To Card option in the System menu.
To obtain a list of all System parameters, you use the command 'sysparas', which lists all of the adjustable
parameters in a table format with their current setting value in brackets. Example: typing sysparas <enter> displays
the following table:
1) Input Source [AES/EBU] 2) Mono Mode [Stereo]
3) Input Phase [Normal] 4) Input Master [0.0dB]
5) Input Left [0.0dB] 6) Input Right [0.0dB]
7) Master Drive [12]
17) Output Master [+10.0dB]
18) Output Left [+10.0dB] 19) Output Right [+10.0dB]
20) DAB Master [+10.0dB] 21) DAB Left [+10.0dB]
22) DAB Right [+10.0dB] 23) Analog Out [FM]
24) AES Out 1 [FM] 25) AES Out 2 [FM]
26) Headphones [-10.0dB] 33) Daypart State [Enabled]
34) Ctrl Port baud [19200] 51) Composite 1 [3.60v]
52) Composite 2 [3.60v] 53) SCA Level [-20.0dB]
54) Pilot Level [8.0%] 55) Separation [Stereo]
56) Phase Adjust [0 Deg] 57) Analog Phase [1]
58) Preemphasis [75 uS] 59) Deemphasis [75 uS]
60) BS412 [OFF] 61) Ave. Power [83]
Setting New Syspara Values
To find the new value you wish to use for a particular Syspara:
sysparavalues <syspara index #> Lists all the possible values for any parameter.)
Example: sysparavalues 54 <enter> Displays a table listing the possible Pilot Level values.
To set a new value for a Syspara:
syspara <syspara index #>[<sysparavalue index #>]
To reset all System parameters back to their factory defaults:
Omnia-6ex Use and Operation Manual – V: 1.10
99