10
6.1.2. Assembly instruction
Step 1. Install Micro-inverter
Mark the approximate center of photovoltaic module on the frame and install the
Micro-inverter with the LED side facing upwards.
The Micro-inverter must be under the module, out of long-term
exposure to direct sunlight or rain.
First Type of Installation (Wall bracket hole):
There are two wall bracket holes in each Micro-inverter as shown in Fig.1 and
Fig.2.Use a pair of screws and nuts to install the micro-inverter onto the bracket as
shown in Fig.5.
Fig.5. Installation Example (Wall Bracket Hole)
To Next Page
Loading...
