What to do if my Omnik Omniksol-2k-TL shows a Utility Loss?
If your Omnik Inverter displays a Utility Loss error, first check the grid connection cables to ensure they are properly connected. Also, verify the grid's usability. If the grid is functioning correctly and the problem persists, the fuse in the inverter may be open, requiring professional service.
Why is my Omnik Inverter showing Grid Fault Fac Over Range Vac Over Range?
The Omnik Inverter might show a Grid Fault, Fac Over Range, or Vac Over Range error if the grid voltage and frequency are outside of normal specifications. Wait briefly to see if the grid returns to normal; the PV-Inverter will restart automatically if it does. Also, ensure that the grid voltage and frequency meet the required specifications.
What to do if my Omnik Inverter displays Over Temperature?
If your Omnik Inverter indicates an Over Temperature issue, it means the internal temperature is too high. Try to reduce the ambient temperature around the inverter or move it to a cooler environment.
What to do for a Ground I Fault on Omnik Omniksol-2k-TL Inverter?
If your Omnik Inverter shows a Ground I Fault, it means the ground current is too high. Disconnect the AC side, unplug the inputs from the PV generator, and inspect the peripheral AC system. After clearing the cause, reconnect the PV panel and AC connection, then check the PV-Inverter status.
What does PV over Voltage mean on my Omnik Inverter?
If your Omnik Inverter displays a PV over Voltage error, check the open PV voltage to see if it exceeds or is close to 500VDC (for Omniksol-1k/1.5k2k-TL). If the PV voltage is less than 500VDC and the problem persists, please call local service.
How to fix Consistent Fault on Omnik Omniksol-2k-TL Inverter?
To resolve a Consistent Fault on your Omnik Inverter, disconnect PV (+) or PV (-) from the input and then restart the inverter.
What to do if my Omnik Inverter shows Relay-Check Fail?
To address a Relay-Check Fail error on your Omnik Inverter, disconnect ALL PV (+) or PV (-). Wait a few seconds until the LCD switches off, then reconnect and check again. If the problem persists, please call local service.
Crucial safety warnings for installation, operation, and maintenance to prevent hazards.
Presents detailed technical specifications for the Omniksol-1k-TL model.
Guidelines and diagrams for mounting the inverter, including orientation and angle limits.
Step-by-step guide for securely mounting the inverter using the provided wall bracket.
Step-by-step guide for mounting the inverter directly to the wall without a bracket.
Electrical connection safety warnings against fire, shock hazards, and proper compliance.
Detailed steps for connecting the AC power, including RCD/RCM and connector assembly.
Guides DC connection, safety for PV connectors, and MC4 assembly for solar cables.
Details the procedure for selecting the correct safety standard during initial inverter startup.
Check impedance and earthing. Ensure impedance is >2MΩ, and AC-side is not earthed.
Check high ground current. Disconnect PV/AC, check peripheral system, then reconnect.
General| Model | Omniksol-2k-TL |
|---|---|
| Rated Power | 2000 W |
| MPPT Trackers | 1 |
| Nominal AC Power | 2000 W |
| Nominal AC Voltage | 230 V |
| Output Frequency | 50/60 Hz |
| Cooling | Natural convection |
| Protection Class | IP65 |
| Max. AC Power | 2000 W |
| Operating Temperature Range | -25°C to 60°C |
To Next Page