3
The symbols on the micro-inverter are list below and illustrated in detail.
Treatment
To comply with European Directive 2012/19/EU on
waste Electrical and Electronic Equipment and its
implementation as national law, electrical equipment
that has reached the end of its life must be collected
separately and returned to an approved recycling
facility. Any device no longer required must be returned
to an author zed dealer or approved collection and
recycling facility.
Caution
Do not come within 8 inches (20cm) of the micro-
inverter for any length of time while it is in operation.
Danger of high voltages
Danger to life due to high voltage in the micro-inverter.
Beware of hot surface
The inverter can become hot during operation. Avoid
contact with metal surfaces during operation.
CE mark
The inverter complies with the requirements of the Low
Voltage Directive for the European Union.
Read manual first
Please read the installation manual first before
installation, operation and maintenance.
2.2. Installation warnings
The SMP300/600 Micro-inverter is designed and tested according to international
safety requirements. However, certain safety precautions must be taken when
installing and operating this inverter. The installer must read and follow all instructions,
cautions and warnings in this installation manual
To Next Page
Loading...
