➢ All operations including transport, installation, start-up and
maintenance, must be carried out by qualified, trained personnel.
➢ Before installation, check the unit to ensure absence of any transport
or handling damage, which could affect insulation integrity or safety
clearances. Choose installation location carefully and adhere to
specified cooling requirements. Unauthorized removal of necessary
protections, improper use, incorrect installation and operation may
lead to serious safety and shock hazards or equipment damage.
➢ Before connecting the Micro-inverter to the power distribution grid,
contact the local power distribution grid company to get appropriate
approvals. This connection must be made only by qualified technical
personnel .It is the responsibility of the installer to provide external
disconnects switches and Over current Protection Devices (OCPD).
➢ When the photovoltaic array is exposed to light, it supplies a D.C.
voltage to the inverter
➢ Only one photovoltaic module can be connected in the input of the
inverter. Do not connect batteries or other sources of power supply.
The inverter can be used only if all the technical characteristics are
observed and applied.
➢ Do not install the equipment in adverse environment conditions such
as flammable, explosive, corrosive, extreme high or low temperature,
and humid. Do not use the equipment when the safety devices do not
work or disabled.
➢ Use personal protective equipment, including gloves and eye
protection when working.
➢ Inform the manufacturer about non-standard installation conditions.
➢ Do not use the equipment if any operating anomalies are found. Avoid
temporary repairs.
➢ All repairs should be carried out using only qualified spare parts, which
must be installed in accordance with their intended use and by a
licensed contractor or authorized Omnik service representative.
➢ Liabilities arising from commercial components are delegated to their
respective manufacturers.
➢ Anytime the inverter has been disconnected from the power network,
use extreme caution as some components can retain charge sufficient
to create a shock hazard. Prior to touching any part of the inverter use
care to ensure surfaces and equipment are at touch safe temperatures
and voltage potentials before proceeding.
➢ Omnik accepts No liability for damage from incorrect or careless
operation
➢ Electrical Installation & Maintenance shall be conducted by licensed
electrician and shall comply with Australia National Wiring Rules
To Next Page
Loading...
