Omnitronic CS-406 User Manual

10050025_V_1_2.DOC
23/28
5.2 Master-section
+12
+12
0
0
-12
-12
+12
+12
0
0
-12
-12
0
0
0
0
0
0
+15
+
15
+15
+15
+
15
+15
-
-
-
-
-
-
SEND
RETURN
DIGITALEFFECT
PROCESSING
DISPLAY
UP
DOWN
GRAPHICEQUALIZER
+48V
+7
+7
+
4
+4
0
0
-4
-4
-10
-10
AUXSEND
AUXRETURN
MAINL
MAINR
ECHO
63Hz
150Hz 400Hz 15kHz1kHz 2.5kHz
6.4kHz
ECHO SELECTOR
For selecting the desired echo length.
SEND
With the Send-control, you can adjust the signal level of the effect generator.
RETURN
With the RETURN-control, you can adjust the input level of the AUX RETURN-socket.
AUX SEND
With the Send-control, you can adjust the output level of the AUX SEND-socket.
AUX RETURN
With the AUX RETURN-control, you can adjust the input level of the AUX RETURN-socket.
7-BAND GRAPHIC EQUALIZER
Used to fine-tune the master output. The frequencies are as follows: 63 Hz, 150 Hz, 400 Hz, 1 kHz, 2.5 kHz,
6.4 kHz and 15 kHz. They can be adjusted by +/- 12 dB.
+48V-SWITCH
With the +48V-switch, you can activate the phantom power for the XLR-sockets of the mic channels. The
phantom power is needed for operating condenser microphones. Connected dynamic microphones may be
operated if they are balanced. If in doubt, please connect your microphone manufacturer.
Please note: the phantom power must only be activated if all microphones are connected and all output
controls are set to minimum position. During the stabilization phase (approx. 1 minute), you must not connect
or disconnect any mics or adjust output volumes. Otherwise danger of speaker damage!
MASTER LEVEL DISPLAY
MAIN MIX CONTROLS
With the Main Mix controls, you can adjust the output signal of the MAIN OUT-sockets.

Omnitronic CS-406 Specifications

General

Brand	Omnitronic
Model	CS-406
Category	Music Mixer
Language	English