(2) Coverage: Omron, at its own discretion, will provide one of the following two services
for malfunctioning Omron products:
(a) Free repair of the malfunctioning Omron products at an Omron maintenance
service location. No repair support is available for electronic components.
(b) Free replacement of the malfunctioning Omron products with the same number
of replacement/alternative products.
(3) Exceptions: Omron will not cover Omron products under its warranty if the cause of
the malfunction falls under any of the following.
(e) Usage in a manner other than the original intended use for the Omron products.
(f) Usage outside of the usage conditions.
(g) Usage of the product against the conditions described in “Note about Use”
(h) Modification or repair made to the Omron product by other than Omron
personnel.
(i) Software program embedded by other than Omron or usage of such software.
(j) Cause which could not have been foreseen with the level of science and
technology at the time of shipping from Omron.
(k) Causes originating from other than Omron or Omron products (including causes
such as, but not limited to, natural disasters).
Limitation of Liability
The warranty set out in these Terms and Conditions is the whole and sole liability for
Omron products. There are no other warranties, expressed or implied. Omron and the
distributors of Omron products are not liable for any damages which may arise from or be
related to Omron products.
Export Controls
Customers of Omron products shall comply with all applicable laws and regulations of
Japan and/or other relevant countries with regard to security export control, when
exporting Omron products and/or technical documents or providing such products and/or
documents to a non-resident. Omron may not provide customers with Omron products
and/or technical documents should they fail to comply with such laws and regulations.