24
appears, or the monitor
is turned off
unexpectedly during a
measurement.
Batteries are depleted.
Immediately replace all
4 batteries with new ones.
Refer to sub-section 2.1.
Nothing appears on the
display of the monitor.
Battery polarities are not
properly aligned.
Check the battery
installation for proper
placement. Refer to sub-
section 2.1.
Readings appear too
high or too low.
Blood pressure varies constantly. Many factors including
stress, time of day, and/or how you apply the arm cuff,
may affect your blood pressure.
Review sub-sections 2.2 - 2.4 and section 3.
Any other problems
occur.
Press the [START/STOP] button to turn the monitor off,
then press it again to take a measurement. If the problem
continues, remove all batteries and wait for 30 seconds.
Then re-install the batteries.
If the problem still persists, contact customer service.
Refer to section 11.
Display/Problem Possible Cause Solution
To Next Page
