Omron BP710CANN - Page 20

20
ERROR MESSAGES AND TROUBLESHOOTING
Error Display Cause Solution
Movement during
measurement and the
arm cuff has not been
inflated sufficiently.
Repeat measurement.
Remain still and do not talk during
measurement.
Refer to Taking a Measurement.
If “E2” appears repeatedly, inflate
the arm cuff manually until it is 30 to
40 mmHg
above your previous measurement
result.
Refer to Taking a Measurement.
The arm cuff was inflated
exceeding the maximum
allowable pressure, and
then deflated
automatically when
inflating the arm cuff
manually.
Do not touch the arm cuff and/or
bend the air tube while taking a
measurement. Do not inflate the
arm cuff more than necessary.
Refer to Taking a Measurement.
Movement during
measurement.
Repeat measurement.
Remain still and do not talk during
measurement.
Refer to Taking a Measurement.
Clothing is interfering with
the arm cuff.
Remove any clothing interfering
with the arm cuff.
Refer to Applying the Arm Cuff.
Device error. Contact Customer Service.