BU1002SW / BU3002SW
75
7
●
How to set up UPS service (set the time to shut down Windows)
1) After performing the setup described in the previous section, click the "Confi gure (C)" button in the
"Power supply options" window.
2) In the "Warning" box, place a check mark in the box to the left of "Time from when battery drive starts
until warning is issued (M)" by clicking on it.
In the window to the right, set the amount of time to wait before starting Windows shutdown after a
power failure occurs. (Setting range: 2 to 720 minutes)
Click the "OK" button.
Click
Check
Set
Click
To Next Page
Loading...
