157
Setting Tag Data Links Section 6-2
The following dialog box will be displayed before the Wizard starts.
Click the Yes Button to delete the connections that have been set with OM-
RON PLCs before starting the Wizard.
3. Create the connection following the instructions that are given by the Wiz-
ard after the Wizard starts. (See the following figure.)
4. A list of tag sets is displayed on the right side of the Wizard Dialog Box with
target devices that support receiving input data.
Select the tag sets that you want to receive at the originator device.
The following tables describes the meanings of the icons and check marks
displayed in the tag set list.
Note Tag sets that are used in connections that are already set are not displayed.
Icon Display position Status
All All output tag sets for all devices are selected.
Device All output tag sets for the applicable device are
selected.
Tag set The applicable output tag sets are selected. These
are the tag sets that will be set in the connection.
All All or some output tag sets for some devices are
selected.
Device Some output tag sets for applicable devices are
selected.
All All output tag sets for all devices are not selected.
Device All output tag sets for applicable devices are not
selected.
Tag set The applicable output tag sets are not selected.
The connections for this tag set will be deleted.
Device No applicable tag sets.
To Next Page
Loading...
