xxi
Unit Versions and Programming Device Versions
The following versions of the CX-Programmer and Network Configuration are
required to set EtherNet/IP Units.
CS1W-EIP21, CJ1W-EIP21,
and CJ2H-CPU@@-EIP
CJ2M-CPU3@
*1: The most recent version of the common module for CX-One version 3.@@ must be
installed.
*2: The most recent version of the common module for CX-One version 4.@@ must be
installed.
*3: The settings cannot be downloaded from the computer to the PLC if more than 20
words of tag data links are set.
*4: A maximum of 20 words of tag data links can be set.
Unit version CX-Programmer
Ver. 7.1 or lower Ver. 8.0 Ver. 8.02 or higher
Unit version 1.0 ---
OK
*1
OK
Unit version 2.0 --- OK OK
Unit version Network Configurator for EtherNet/IP
Ver. 3.00 or higher
Unit version 1.0 OK
Unit version 2.0 OK
Unit version CX-Programmer
Ver. 9.0 or lower Ver. 9.1 Ver. 9.2 or higher
Unit version 2.0 --- OK OK
Unit version 2.1 ---
OK
*2
OK
Unit version Network Configurator for EtherNet/IP
Ver. 3.1 or lower Ver. 3.20 Ver. 3.21 or higher
Unit version 2.0 --- OK
OK
*3
Unit version 2.1 ---
OK
*4
OK
To Next Page
Loading...
Need help?
General
