274
Adjusting the Communications Load Section 10-2
Method 2: Changing a Particular Device’s RPI Setting
The usage of capacity can be adjusted for only a particular device by
changing the packet intervals (RPI) for all of the device’s connections to-
gether. In this case, the usage of capacity will also change for the devices
that are the target devices of the connection which was adjusted.
a. Click the Set Packet Interval (RPI) Button at the bottom of the Usage
of Device Bandwidth Dialog Box.
b. The Set Packet Interval (RPI) Dialog Box will be displayed. In the Tar-
get Device Area, deselect the target devices that are not being adjust-
ed by removing the check marks.
c. Input a new RPI value, and click the OK Button.
Method 3: Changing a Particular Connection’s RPI Setting
The usage of capacity can be adjusted by individually changing the packet
intervals (RPI) setting for a particular connection. In this case, the usage
of capacity will also change for the device that is the target device of the
connection which was adjusted.
To Next Page
Loading...
Need help?
General
