Omron CK3E Series - Mounting Direction in Cabinets or Control Panels; Installation in Cabinets or Control Panels

Motion
C
ontroller
Power lines
200 mm min.
200 mm min.
• Ground the mounting plate between the Controller and the mounting surface.
4-3-1
Mounting Direction in Cabinets or Control Panels
The Motion Controller can be installed facing the front or sideways.
The Controller must be mounted in an upright position to provide appropriate cooling.
Front mounting Sideways mounting
4-3-2
Installation in Cabinets or Control Panels
The following shows the mounting method of the Motion Controller.
It is recommended that M4 screws be used for mounting.
1 Create holes for the screws used to mount the Motion Controller.
The screw positions are as follows.
4 Mounting and Wiring
4-6
CK3E-series Programmable Multi-Axis Controller User’s Manual Hardware (I610)