Omron E5CC User Manual

6 Parameters
6 - 72
E5@C Digital Temperature Controllers User’s Manual (H174)
prlt
Move to Protect Level Time
• This parameter sets the key pressing time required to move to the Protect Level from the
Operation Level, the Adjustment Level, or Monitor/Setting Item Level.
cjc
Cold Junction Compensation
Method
Input type must be thermocouple or infrared
temperature sensor
• This parameter specifies whether cold junction compensation is to be performed
internally by the Digital Controller or to be performed externally when the input type
setting is 5 to 24.
• The cold junction compensation external setting is enabled when the temperature
difference is measured using two thermocouples or two ES1B Sensors.
 Related Parameters
Input Type (Initial Setting Level): Page 6-43
Function
Setting
Setting range Unit Default
1 to 30 Seconds 3
Function
Setting
Setting range Default
on: Internally, off: Externally on
See
See

Omron E5CC Specifications

General

Number of Display Digits	4 digits
Number of Control Outputs	1
Control Method	ON/OFF
Input Type	Thermocouple, RTD, Analog voltage, Analog current
Supply Voltage	100 to 240 VAC
Output Type	Relay, Voltage, Current
Display Type	LCD
Size	48 x 48 mm
Mounting Method	Panel mount
Control Output	Relay, Voltage, Current
Alarm Output	Relay
Communication	RS-485
Ambient Operating Temperature	-10 to 55°C
Ambient Operating Humidity	25% to 85% RH
Protection Rating	IP66