E5CK
E5CK
12
Setup Mode
2
100
i n -h
0
0
c
Input Type
Codes are used to determine the input types connected to terminals 6 to 8.
Scaling Upper Limit
Used if the input type connected to the Controller is an analog input (voltage or current input).
Scaling Lower Limit
Used if the input type connected to the Controller is an analog input (voltage or current input).
Decimal Point
Used if the input type connected to the Controller is an analog input (voltage or current input).
°°C/ °°F Selection
Used if the input type connected to the Controller is a temperature input (thermocouple or platinum
resistance thermometer).
Parameter Initialize
Control Output 1 Assignment
Enables the Controller to have heating control, cooling control, alarm 1, alarm 2, alarm 3, and LBA
(loop break alarm) outputs.
Control Output 2 Assignment
Enables the Controller to have heating control, cooling control, alarm 1, alarm 2, alarm 3, and LBA
(loop break alarm) outputs.
Auxiliary Output 1 Assignment
Enables the Controller to have alarm 1, alarm 2, alarm 3, LBA (loop break alarm), error 1, and error 2
outputs.
Alarm 1 Type
Alarm 1 Open in Alarm
Alarm 2 Type
Alarm 2 Open in Alarm
Direct/Reverse Operation
no
heat
al-1
al-2
2
n-o
2
n-o
i n -l
d p
d - u
a l 1 n
a l 2 n
i n it
o u t 1
o u t 2
a l t 2
or-r
o r e U
i n -t
s u b 1
a l t 1
Availableonlywhen theController has an alarm
output (see the table on the next page).
To Next Page
Loading...
