Omron E5AR - MANUAL 2 User Manual

Printed in Japan
0505-0.5M (0305) (B)
Note: Specifications subject to change without notice.Cat. No. Z182-E1-03
Authorized Distributor:
User's Manua
l
D
igital
C
ontrolle
r
Cat. No. Z182-E1-03
OverviewPreparations
Typical Control
Examples
Settings Required
for Basic Control
Functions and
Operations
Communication
(CompoWay/F)
Communication
(Modbus)
Setting data
User calibrationTroubleshooting
Appendix
E5AR / E5ER Digital Controller User's Manual Cat. No. Z182-E1-03
OMRON Corporation
Industrial Automation Company
Control Devices Division H.Q.
Analog Controller Division
Shiokoji Horikawa, Shimogyo-ku,
Kyoto, 600-8530 Japan
Tel: (81)75-344-7080/Fax: (81)75-344-7189
Regional Headquarters
OMRON EUROPE B.V.
Wegalaan 67-69, NL-2132 JD Hoofddorp
The Netherlands
Tel: (31)2356-81-300/Fax: (31)2356-81-388
OMRON ELECTRONICS LLC
1 East Commerce Drive, Schaumburg, IL 60173
U.S.A.
Tel: (1)847-843-7900/Fax: (1)847-843-8568
OMRON ASIA PACIFIC PTE. LTD.
83 Clemenceau Avenue,
#11-01, UE Square,
239920 Singapore
Tel: (65)6835-3011/Fax: (65)6835-2711
OMRON (CHINA) CO., LTD.
Room 2211, Bank of China Tower,
200 Yin Cheng Road (M),
Shanghai, 200120 China
Tel: (86)21-5037-2222/Fax: (86)21-5037-2200

Omron E5AR - MANUAL 2 Specifications

General

Brand	Omron
Model	E5AR - MANUAL 2
Category	Controller
Language	English

Summary

Introduction

Precaution in using the product

Important safety precautions and guidelines for using the controller under specific conditions.

Warranty and Limitations of Liability

Application Considerations

Precautions

Precautions for Safe Use

Precautions for Correct Use

Section 1 Overview

1.3 Input/output Configuration and Main Functions

Diagrams and explanations of input/output configurations and the controller's main functions.

Section 4 Settings Required for Basic Control

4.1 Setting levels and key operation

Explanation of the controller's setting levels and the keys used for navigation and operation.

4.3 Initial setting examples

Step-by-step examples for configuring initial settings like sensor input type and control mode.

Section 5 Functions and Operations

5.1 Input adjustment functions

Functions for adjusting input signals, including input shift, first order lag, and move average.

5.2 Control functions

Explanation of advanced control functions like SP ramp, banks, and PID sets.

5.3 Output adjustment functions

Section 6 Communication (CompoWay/F)

6.1 Communication method

Section 7 Communication (Modbus)

7.1 Communication method

Section 8 Setting data

8.2 Protect level (l.prt)

Section 9 User calibration

9.3 Thermocouple input calibration

Step-by-step guide for calibrating thermocouple inputs, including preparations and procedures.

Section 10 Troubleshooting

10.1 Troubleshooting checklist

A systematic checklist to help identify the cause of controller malfunctions.

10.2 Error messages

Explanation of error messages displayed by the controller and their solutions.

10.3 Inferring causes from conditions (abnormal measured values)