5.7 Using event input
5-29
Functions and
Operations
5.7 Using event input
• Event input can be used on the E5AR-@@B (2-input), E5ER-@@B(2-
point), E5AR-@@D (4-point), E5ER-@@D (4-point), and E5AR-
@@DB (6-point).
• An order of priority exists for event input, key operation, and commu-
nication settings, with the most recent setting taking precedence.
• Operation changeover takes place when event input switches "OFF
→ ON" and "ON → OFF".
■ Event input allocation
• Function settings for event input using external contact input are
configured using "Event input allocation 1 to 6".
• On a multi-point input type, assignment data can be set for channels
2 and higher as appropriate for the number of channels.
● Communication
write OFF/ON
• When the event input is ON, setting data can be written with the
communication function and the "CMW" indicator lights up. The
content of the event input is reflected in "Communication OFF/ON"
(Adjustment level).
• This setting data is an operation command that is common to all
channels.
• Operation is as follows based on the event input ON/OFF state.
eV.6
0
l.2
eV.1
0
l.2
Event input 1 assignment
Write via communication OFF/ON
Channel 2 Bank No. (bit 0)
Channel 2 Bank No. (bit 1)
Channel 2 Bank No. (bit 2)
Channel 2 run/stop
Channel 4 auto/manual
Channel 4
Write via communication OFF/ON
Channel 2 Bank No. (bit 0)
Channel 2 Bank No. (bit 1)
Channel 2 Bank No. (bit 2)
Channel 2 run/stop
Channel 3 auto/manual
Channel 3
Write via communication OFF/ON
Channel 2 Bank No. (bit 0)
Channel 2 Bank No. (bit 1)
Channel 2 Bank No. (bit 2)
Channel 2 run/stop
Channel 2 auto/manual
Channel 2 SP mode (remote/local)
Channel 2
EV1
EV2
EV3
EV4
EV5
EV6
Event input Event input assignment
Write via communication OFF/ON
Channel 1 Bank No. (bit 0)
Channel 1 Bank No. (bit 1)
Channel 1 Bank No. (bit 2)
Channel 1 run/stop
Channel 1 auto/manual
Channel 1 SP mode (remote/local)
Channel 1
Event input Description
OFF Write via communication OFF
ON Write via communication ON