Section 6 Communication (CompoWay/F)
6-22
Communication
(CompoWay/F)
Response codes: The above indicates a normal end. For the response
codes, see "6.7 Operation commands (Communication/CompoWay/
F)" (P.6-11).
■ Bank change
This command is used to change banks (there are 8 banks numbered
0 to 7). An SP, alarm values, and a PID Set No. are stored in each
bank.
This command can be used in both setting area 0 and setting area 1.
• An operation error will result if AT is running in the selected channel.
To use this command, "Write via communication" must be enabled
using the "Write via communication" operation command.
Response codes: The above indicates a normal end. For the response
codes, see "6.7 Operation commands (Communication/CompoWay/
F)" (P.6-11).
Response
"30" "05" "0000"
Response code
SRCMRC
Related
information
Description
Ch Bank No. selected
"00" to "07" 1 0 to 7
"10" to "17" 2 0 to 7
"20" to "27" 3 0 to 7
"30" to "37" 4 0 to 7
"F0" to "F7" All 0 to 7
Command
"30" "05"
SRC
"02"
Instruction
code
Related
information
MRC
Response
"30" "05" "0000"
Response code
SRCMRC
To Next Page
Loading...
