Omron E5AR - MANUAL 2 User Manual

Section 4 Settings Required for Basic Control
4-2
Settings Required
for Basic Control
4.1 Setting levels and key operation
The settings are grouped into levels and the set values are called setting data. On the E5AR/ER, the
settings are grouped into 17 levels as shown below.
When the power is turned on, all indicators light up for 1 second. The initial level after power-on is "RUN
level".
Control initial
setting level
Control initial
setting 2 level
Communications
setting level
Display
adjustment level
Special function
setting level
Expansion control
setting level
Alarm setting level
Protect level
Control in operation
Control stopped
Control is stopped on all
channels of multi-point input
type.
1
250
00
00
Calibration level
Reset from calibration level is by power off.
1
250
00
00
Password input Set value (in general) 1201
Password input Set value (in general) -169
Blinks at L1 seconds or longer
L3 seconds or longer
Less than
L1 seconds
Less than
L1 seconds
Less than
L1 seconds
Less than
L1 seconds
Less than
L1 seconds
Less than
L 1 seconds
Less than
L 1 seconds
Blinks at L + M
L+M
3 seconds
or longer
L+M
1 second
or longer
L1 seconds or longer
Less than
L1 seconds
Less than
L1 seconds
L1 seconds or longer
Less than
L1 seconds
Less than
L1 seconds
Less than
L1 seconds
Less than
L1 seconds
Less than
L1 seconds
Less than
L1 seconds
Adjustment level
Adjustment 2 level
Bank setting level
Monitor item level
Approximation
setting level
PID* setting level
RUN level
Power on
Input initial
setting level

Omron E5AR - MANUAL 2 Specifications

General

Brand	Omron
Model	E5AR - MANUAL 2
Category	Controller
Language	English