4-1
Settings Required
for Basic Control
Section 4 Settings Required for Basic Control
4.1 Setting levels and key operation ........................................ 4-2
4.2 Set values .......................................................................... 4-4
4.3 Initial setting examples ...................................................... 4-5
4.4 Setting the input type......................................................... 4-8
4.5 Selecting the temperature units ....................................... 4-12
4.6 Selecting the control mode .............................................. 4-13
4.7 Setting output parameters ............................................... 4-14
4.8 Setting and changing the SP ........................................... 4-17
4.9 Performing ON/OFF control ............................................. 4-18
4.10 Determining the PID constants (AT, manual settings)...... 4-20
4.11 Using auxiliary output ...................................................... 4-23
4.12 Starting and stopping control........................................... 4-27
4.13 Performing manual control............................................... 4-29
4.14 Changing channels .......................................................... 4-31
4.15 Operational considerations.............................................. 4-32
To Next Page
Loading...
Need help?
General
