E5CK
E5CK
10
Level 1 Mode
off
a t
0
s p - 0
0
0
0
AT Execute/Cancel
Set Point 0
Used with multi-SP function.
Set Point 1
Used with multi-SP function.
Alarm Value 1
Available only when the alarm output function of the Controller is selected.
Alarm Value 2
Available only when the alarm output function of the Controller is selected.
Proportional Band
Integral Time
Derivative Time
Cooling Coefficient
Used when the Controller is in heating and cooling control.
Dead Band
Used when the Controller is in heating and cooling control.
Manual Reset Value
Available when the integral time parameter of the Controller in standard control is “0.”
Hysteresis (Heat)
Available when the Controller is in ON/OFF control.
Hysteresis (Cool)
Available when the Controller is in ON/OFF control in heating and cooling control.
10.0
p
233
i
d
40
1.00
0.0
c - d b
50.0
h y s
0.10
0.10
s p - 1
a l - 1
a l - 2
c - s c
o f -r
c h y s
Control Period (Heat)
Available when the Controller has a relay or voltage output, or is in advanced PID control.
Control Period (Cool)
Availablewhenthe Controllerhas arelay orvoltage output, or isin advanced PID controlin heatingand
cooling control.
20
c p
20
c - c p
To Next Page
Loading...
