E5CK
E5CK
9
Parameters Operation
Level 0 Mode
0
1 3 0 0
0
s p - m
50.0
o
c - o
50.0
r -5
run
PV/SV
The process value is displayed on the No.1 display and the set point is displayed on the No.2 display.
When the multi-SP function is in use, the value of whichever is set, set point 0 or 1, is linked.
Set Point During SP Ramp
Monitors the set point when the SP ramp function is used.
MV Monitor (Heat)
MV Monitor (Cool)
Used when the Unit is in heating and cooling control operation.
Run/Stop
off
Security
Any mode marked with“X” inthe followingtable isnot displayedon themenu whenthis parameteris setto
“0” to “3.”
The Unit will be in only level 0 mode and the menu will not be available when this parameter is set to “4” to
“6.”
Only the “PV/SP monitor” and “set point” parameter can be used when this parameter is set to “5.”
Only the “PV/SP monitor” parameter can be used when this parameter is set to “6.”
A/M Key Protect
Invalidate the function of the A/M Key.
MV Manual
Mode Set value
Calibration
Option
Expansion
Setup
Level 2
Level 1, 0
0 1 2 3 4
x x x x
x x x
x x x
x x x
x x
x
k e y p
Process value
Manipulated variable
MANU indicator
16.0
3 8. 8
s e c r
1
key p
off
key p
off
To Next Page
Loading...
