E5CK
E5CK
19
Installation
Installation
Main Parts
Terminals
Output Unit
Rear case
Front panel
Option Unit
Input type jump-
er connector
Draw-out
First, draw out the internal mechanism from the housing.
Pull out the internal mechanism while pressing the hooks on the left
and right sides of the front panel.
Setting Up the Output Unit
1. Two rectangular holes are provided on the power board (right
side of Controller). Fit the two protrusions of the Output Unit
into these two holes.
2. With the Output Unit fitted into the power board, fit the Output
Unit into the connector on the control board (left side of
Controller).
1
2
Setting Up the Option Unit
1. Place the Controllerwith itsbottom facingup, andfittheboard
horizontally intothe Connector on the power board (right side
of controller).
2. With the power board connected, fit the board vertically into
the Connector on the control board (left side of controller).
1
2
To Next Page
Loading...
