E5CK
E5CK
23
Precautions
Period and Scope of Guarantee
Unit with Standard Specifications
Scope of Guarantee
Should the Unit malfunction during the guarantee period, OMRON
shall repair theUnit or replaceany parts of theUnitatthe expenseof
OMRON.
The above does not apply in the following cases.
1. Any malfunction of the Unit due to the incorrect use or
improper handling of the Unit.
2. Any malfunction of the Unit not originating from the Unit.
3. Any malfunction ofthe Unit dueto amodification ofthe Unitor
repairs to theUnit carriedout byany personnot authorizedby
OMRON.
4. Any malfunction of the Unit due to any natural disaster.
OMRON shall notberesponsible forany damageorloss inducedby
any malfunction of the Unit.
Three-year Guarantee
Period of Guarantee
The guarantee periodof theUnit isthreeyears startingfromthedate
the Unit is shipped from the factory.
Scope of Guarantee
The Unit is guaranteed under the following operating conditions.
1. Average Operating Temperature (see note): 10°°C to 50°°C
2. Mounting Method: Standard mounting
Top
Bottom
Note: Average Operating Temperature
Refer to the process temperature of the Unit mounted to a
control panel and connected to peripheral devices on
condition that the Unit is in stable operation, sensor input
type K is selected for the Unit, the positive and negative
thermocouple input terminals of the Unit are short-cir-
cuited, and the ambient temperature is stable.
Should the Unit malfunction during the guarantee period, OMRON
shall repair theUnit or replaceany parts of theUnitatthe expenseof
OMRON.
The above does not apply in the following cases.
1. Any malfunction of the Unit due to the incorrect use or
improper handling of the Unit.
2. Any malfunction of the Unit not originating from the Unit.
3. Any malfunction ofthe Unit dueto amodification ofthe Unitor
repairs to theUnit carriedout byany personnot authorizedby
OMRON.
4. Any malfunction of the Unit due to any natural disaster.
OMRON shall notberesponsible forany damageorloss inducedby
any malfunction of the Unit.
OMRON Corporation
Systems Components Division
28th Fl., Crystal Tower Bldg.
1-2-27, Shiromi, Chuo-ku,
Osaka 540 Japan
Phone: 06-949-6012 Fax: 06-949-6021
ALL DIMENSIONS SHOWN ARE IN MILLIMETERS.
To convert millimeters into inches, multiply by 0.03937. To convert grams into ounces, multiply by 0.03527.
Cat. No. H79-E1-4 In the interest of product improvement, specifications are subject to change without notice.
Printed in Japan
0297-2M (0995) a
To Previous Page
Loading...
