Omron E5CN Manual

SYSWAY
4.2 Command Descriptions
4-9
● Alarm
Only alarms 1 and 2 are supported.
Alarm 3 cannot be used.
● Heater Burnout Detection
Reads “heater burnout detection 1.” (The “heater burnout 2 detection”
value is not read.)
■ Select Communications Writing
The logic of the MB command changes as shown in the table below
according to the MB command logic switching setting (advanced
function level). The MB command (communications writing selection) is
equivalent to the E5@J Controller’s MB command (remote/local
switching).
• The default value of the MB Command Logic Switching Setting is OFF
(same logic as E5@J).
Text data of MB
command
MB command logic switching setting
OFF ON
0000
Communications writing
enabled (remote mode
selection)
Communications writing
disabled (local mode
selection)
0001
Communications writing
disabled (local mode
selection)
Communications writing
enabled (remote mode
selection)

Omron E5CN Specifications

General

Communication	RS-485 (optional)
Mounting	Panel Mount
Control Method	ON/OFF
Input Type	Thermocouple, RTD
Supply Voltage	100 to 240 VAC
Output Type	Relay, Voltage (for driving SSR), Current
Display Type	7-segment LED
Size	48 x 48 mm
Control Output	Relay, Voltage (for driving SSR), Current
Alarm Output	1 or 2 outputs
Dimensions	48 x 48 x 78 mm
Ambient Operating Temperature	-10 to 55°C
Protection Rating	IP66