Temperature Controllers E5CSZ 11
Installation
• All models in the E5CSZ Series conform to DIN 43700 standards.
• The recommended panel thickness is 1 to 4 mm.
• Be sure to mount the E5CSZ horizontally.
Mounting the E5CSZ
1. Insert the E5CSZ into the mounting hole in the panel.
2. Push the adapter from the terminals up to the panel, and temporarily fasten the E5CSZ.
3. Tighten the two fastening screws on the adapter. Alternately tighten the two screws little by little to maintain a balance. Tighten the screws to a
torque of 0.29 to 0.39 N·m.
Tightening screw
Tightening screw
Adapter
Panel
To Next Page
Loading...
